Go Down

Topic: doesnt launch patch @ external power (Read 634 times) previous topic - next topic

Yo,

New here ;-) got a question.

Using  the Blinking LED tutorial for this test...

When i upload a patch tru USB, every thing works just fine.

When i disconnect the USB and than reconnect, after a few seconds the thepatch relaunches and works again fine to ;-)

Now if i put the jumper to external and hookup a 9 volt battery to the External Power Supply In, the power led goes on, the pin 13 led blinks a bit at boot, than nothing, the patch won't launch  >:(

Now if i for a seccond plug the USB connector in and out, the board launches the patch and the led blinks on battery power just fine...

Am i missing something here? shouldnt the patch just launch on battery after a few seconds?

I have 2 arduinos and both do exactly the same...

-M-

drbunsen

Hi,

really fun. I've exactly the same problem and search this forum for about a hour finding nothing. So I decided to start a new thread and what did I found ... :D

As I said, I have the same problem. I tried the 9V-Battery too. Also I tried various 9- and 12-V-DC powersupplies. I already thought that I got a broken board.

Daniel

hi

usually this is due to the serial port hanging when the bootloader starts.

Try this link to the forum discussion of the same problem:
http://www.arduino.cc/cgi-bin/yabb2/YaBB.pl?num=1170458543

D



drbunsen

Thanks, that was the information I needed. Now it runs perfect.



Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy