Go Down

Topic: Express PCB, board layout (Read 7235 times) previous topic - next topic

jeeep

Hey all,
  I'm looking for the Arduino diecimila / duemilanove board layout for Express PCB. Does anyone have this? Thank you.

bohne

I am not sure if this is what you are looking for, but you can find the
EAGLE files and Schematic here:

http://arduino.cc/en/Main/ArduinoBoardDuemilanove
http://www.dorkbot.de
http://www.arduino.cc/cgi-bin/yabb2/YaBB.pl?num=1236434254
http://www.luminet.cc

JoeJ

Here is An ExpressPCB template file for making shields or your own arduino board

JoeJ

Here is An ExpressPCB template file for making shields or your own arduino board:

http://www.joejaworski.com/arduino_shield.zip

AltairLabs

Quote
Here is An ExpressPCB template file for making shields or your own arduino board:

http://www.joejaworski.com/arduino_shield.zip


@ JoeJ  thanks a million for that I love it !  

Your website says
Quote
Web site and all contents © Copyright 2010 Joe Jaworski, All rights reserved.

Which would not bother me except I have remixed and would like to distrubute this as open source under CC ShareAlike 3.0  Have I permission to do this?

Alternatively I will email you (or anyone) my 2 new .pcb files which I hereby release under CC ShareAlike 3.0 license. You can add my $0.02 and host the zip file if you will release yours under the same Open Source terms.

My remix is two .pcb files to take advantage of Xpress PCB's very economical 'miniboard service' which is restricted to boards exactly 3.8 x 2.5 inches.  Of course a shield is not that size, thus 2 versions.

arduino_shield_miniboard_long.pcb (portrait)
Aligns the 'usb end' with miniboard edge, and is centered to be 0.200" wider on both sides.  It extends 1.1" beyond Arduino's 'back end'.  The Arduino outline is silkscreened for those who wish to trim miniboard to Arduino standard.


arduino_shield_miniboard_wide.pcb (landscape)
Centered to be 0.850" wider on both sides, providing wings for terminals etc.  To fit Arduino's 'back end' it falls 0.20" short on Arduino 'USB end', but no harm since no risers near 'USB end'.  Again the Arduino outline is silkscreened for those who wish to trim miniboard to Arduino standard.


@JoeJ please advise if you release your work as Open Source.

Disclaimer: I have no association with Xpress PCB, nor any other interest except for being a penny pincher.  My two previous orders were fast, cheap and completely satisfactory.  Their schematic and layout software and resulting file types ARE PROPRIETARY and deliberately non-compatible with anything else.  Otherwise I have no gripe against them.

AltairLabs

@jeeep  pls PM me with your email address if you want my miniboard versions.  I assume its OK with JoeJ since he replied to your thread, his copyrighted web site was probably just a convenient place for him to host his zip file.  

Just tried uploading JoeJ's zip file as a Google doc, seems to work fine but I dont wanna publish that URL until we know fer sher thats ok with JoeJ.

AltairLabs

This may fit better under Hardware > Development or Hardware > Interfacing but dont know how to move a thread and dont wanna cross-post.  Suggestions?

Go Up