Go Down

Topic: WiFi 101 Library cannot work with Watchdog (Read 5749 times) previous topic - next topic

Hi all,

I had some troubles with a hanging WiFi-Connection in my Arduino Mega with a WiFi shield (more about this later, I am still investigating), and I wanted to get a more stable system by activating the Watchdog:

Code: [Select]
#include <avr/wdt.h>
Serial.print("Enabling WDT ... ");
wdt_enable(WDTO_8S); // wdt_reset() has to be called at least every 8 seconds, or the Arduino will reboot
void loop(){

    // Do main stuff

But it turned out that the WiFi Library https://github.com/arduino-libraries/WiFi101 does not work with the watchdog :(

There are lots of timeouts in the Library like this:

Code: [Select]
// Wait for connection or timeout:
unsigned long start = millis();
while (!IS_CONNECTED && millis() - start < 20000) {

which of course causes the watchdog to reboot the Arduino if the action takes longer than 8 seconds (and I had that in places like WiFiClient::connect or WiFiClient::write, mainly when the WLAN connection is not so good, or the WLAN has been turned off).

I reduced all these timeouts to max. 6 seconds, and this worked fine for me. But probably there is a reason for the high timeouts - is there?

An alternative would be to add a wdt_reset(); to all these loops.

What do you think?

And another question: I found in some posts that you should not do a busy wait, but put a delay in the code (e.g. when trying to open a WiFi connection in a loop).

The above code in the WiFi Library does a busy waiting - at least as far as I have seen there is no delay() in m2m_wifi_handle_events() and below.

Would it be better to put a short delay in the while-loop above?

Thanks for any comments,

Go Up