Go Down

Topic: Error Uploading (Read 1 time) previous topic - next topic

Nandan_Shukla

Hey  there!

  My arduino is misbehaving. When I upload sketch the rx tx led blink one by one and then it says Error uploading. If it's blown up please guide me.

With Warm Regards,
Nandan Shukla

kostos

Hello, Nandan!
You know that gx and tx connections should be disconnect from Arduino when you load a sketch.

----
Regards, Konstantin.

Nandan_Shukla


Nandan_Shukla


pran4ajith

Did you check the port number under the tools menu-->serial ports.
And also please check if your board shows up under the ports section of your device manager.

Nandan_Shukla

Yes,
I checked it all but since you are insisting i'll check it again.
thanks for your assistance.

Nandan_Shukla

yup ,
It's showing.
Now what?

MADHAN

I have an uploading error. Can someone tell me how to clear the memory or reset Arduino's memory?

CHANDRAN-K

Tell me if the atmel is heating during uploading or not and tell me wether your last program is working.



Go Up