lvergara21, what is your status with this at the moment?
I notice you have in your main() the Serial.begin(9600).
Normally you do this only once, so the best place for that is in your Setup().
el_supremo is correct, you will most likely not be using the same scale factor value for both reading volts as current.
Also, where in the wind turbine circuit are you making the measurement, AC or DC side?
How are you measuring the current that you want to read from the wind turbine?
Typically, it is one of two methods, either a standard current shunt bar with an op-amp to bring up the mV to a higher value.
Or, secondly, a hall effect chip like the ACS712?
Paul