sono un newbie e smanetto da poco con arduino, ho un ipod con schermo a colori che ha l'hd rotto e volevo collegarlo in qualche moto ad arduino o recuperare qualche pezzo ma non so da dove iniziare.
Avete suggerimenti?magari come collegare il monitor dell'ipod ad arduino.
Connector pinout (I've called pin 1 as shown above - nearest the edge of the LCD frame) Pin Function 1 Not Used 2 3.1V Supply 3 1.8V Presumably I/O supply. All I/Os run at 1.8v levels. hopefully this pin can be set to 3V or 3.3v for 3V IO - I'll wait til I have ID'd the controller, or have an expendable display before testing this! 4 0V 5 /Reset. 6 /CS Chip select 7 /WR write strobe 8 RS Selects command/data register ( called CD in some datasheets) 9 /RD read strobe
Data bus Colour* 10 D0 Blue 0 11 D1 Blue 1 12 D2 Blue 2 13 D3 Blue 3 14 D4 Blue 4 15 D5 Green 0 16 D6 Green 1 17 D7 Green 2 18 0V 19 D8 Green 3 20 D9 Green 4 21 D10 Green 5 22 D11 Red 0 23 D12 Red 1 24 D13 Red 2 25 D14 Red 3 26 D15 Red 4 27 0V 28 Vsync out. Goes high for 84.5us at frame rate of 47Hz 29 0V 30 Backlight - 31 Backlight + Vf is 13.7V ( 4 white LEDs in series) 32 Not used
sarà un macello, in quanto ho preso anche il saldatore(dremel) ma pratica zero.
da qui mando i dati per essere visualizzati, giusto?
10 D0 Blue 0
11 D1 Blue 1
12 D2 Blue 2
13 D3 Blue 3
14 D4 Blue 4
15 D5 Green 0
16 D6 Green 1
17 D7 Green 2
18 0V
19 D8 Green 3
20 D9 Green 4
21 D10 Green 5
22 D11 Red 0
23 D12 Red 1
24 D13 Red 2
25 D14 Red 3
26 D15 Red 4
dovresti recuperare un connettore smd come quello sull'ipod e farti un circuito stampato che renda i piedini saldabili a dei fili.
fatto questo dubito che arduino abbia la potenza necessaria per caricare i dati nel display (la ram è molto piccola reciò dovresti calcolarti i pixels al volo mentre trasferisci i dati)
dovresti usare un chip che si occupi solo della grafica...
usare il tastierino sensibile alla rotazione sarà difficile?
un'idea al volo usarlo come scratch tipo dj? arduino decodifica posizione dito e il pc fa avanzare la traccia in base alla posizione.
il chip collegato tramite cavetto in alto a dx a cosa serve? non si legge il codice... è mica una specie di eproom?