Go Down

Topic: Windows Remote Arduino not working with mega (Read 10421 times) previous topic - next topic

radioampdoc

Mar 31, 2016, 04:41 pm Last Edit: Mar 31, 2016, 04:59 pm by radioampdoc
I loaded the StandardFirmata sketch in my Uno and Mega.  Using the Windows Remote Arduino app, it sees the Mega but will not log in via USB as it does with the Uno.

The error I get is:
Connection attempt failed: A device connection was established, but the device failed handshaking procedures.  Verify your device is configured with StandardFirmata.  Message: catastrophic failure.

Pin config not received.

Thanks for any advice you have.
RR

ogoksel

I got same error, are there anyone tests mega with WRAE


Go Up