I am writing a G-code interpreter and have run into a problem. When the X and Y axis get to their desired position (Right now I just have it return the axis and a .01 unit movement over serial) they just move +0.01 and -0.01 back and forth. How can I get it to stop it when it reaches the desired po…

If statement seeming to not work?

system April 23, 2009, 12:57am 6

abs is available but is still doesn't work.

Topic		Replies	Views
Retrieving numbers from the serial communication Programming Questions	5	1273	May 5, 2021
G-code - what am I doing wrong here Programming Questions	25	4575	May 5, 2021
If statement not working Programming Questions	9	601	May 12, 2021
Two dimensional char array, and if-statement Programming Questions	16	1253	May 6, 2021
if statement not working Programming Questions	4	541	May 5, 2021