A simple wire question (FTDI)

Ok I have an FTDI board,what wire do I use?.
Sounds crazy but I'm looking for something a little more permanent that wont just fall out like a wire can.
it has headers like an arduino any Ideas?.
Thanks

Use crimp-terminated wires from pololu.com in a crimp connector housing.
They plug in nice & solid.

Thanks
Just what I was looking for, but $5 for 4 wires I think Ill get the 100 pack pins make my own now I know what to get.

perkunas:
Ok I have an FTDI board,what wire do I use?.
Sounds crazy but I'm looking for something a little more permanent that wont just fall out like a wire can.
it has headers like an arduino any Ideas?.

Just solder some straight 36 Way Single Row Header 0.1 inch pitch or right angle 36 Way Single Row Header Right Angle 0.1 inch pitch headers onto the board (assuming this is a DIY board) run wires to the relevant ATmega pins and plug the FTDI straight into it.

If you don't want to solder headers, there are always pogo pins:
https://www.sparkfun.com/tutorials/138