CrossRoads:
The TPIC6B595 can only pull pins low. Current limit resistors to +5V drive the anodes high, the '595 outputs bring the cathodes low to turn them on.
Hi
Sorry but I'm pretty new to electronics so this might be stupid... does this mean that I have to connect the positive side of my led to my 5v and my negative to my resistor and to the TPIC6B595N? I made a new sketch like this.
In any case, I'm basing my design on this link. My original question was if it would be better and possible to use 2 times the TPIC6B595N to build a matrix, if I understood correctly this is not possible?
Thanks!