32ch servo controller

Community General Discussion
1

Hi, is there anyone experience This torobot 32ch servo controller?can i use Arduino software on this chinese broad?
If yes , i needed help to know the setup of this board from how to use torobot software to executed and run.
I have read all manul Instruction and don't understands... :cold_sweat:
I have test connected servo and run the software but servo keep runing one direction verytime i executed :cold_sweat:baud9600,.
I think i really needed a step by step learing.. please let me know any site or link for me to follow...
I really needed you guy professional knowledge....

Hope I'm not posting to the wrong site :~

2

Magmarco:
I have test connected servo and run the software but servo keep runing one direction verytime i executed

What do you mean by "keep runing one direction"? A servo will have a physical stop and can only turn about 180 degrees.

Did you read this article? Torobot 32 channel servo controller - Bajdi electronics
And this article: http://letsmakerobots.com/content/arduino-and-chinese-32-channel-servo-controller

3

Thanks for your reply John.
sorry for my bad English. .. :sweat_smile: maybe I should take a video to show you.
hope you can advise..