I think I partially burnt my 328 from the MintDuino kit. It's still programmed to run the example Blink sketch, but when I swap it into my UNO R3 board it refuses to accept a new program though it still runs the original Blink sketch.
I uploaded the sketch to my good 328 and watched the Rx and Tx LEDs (both Rx and Tx LEDs flash then the D13 LED blinks) and then did the same with the MintDuino 328 (the Rx flashes three times and then the D13 LED does the original Blink sketch)
I changed the sketch to make it blink faster so I could tell if the MintDuino took the new sketch.
will burning the bootloader fix this or do you think I've toasted the Rx/Tx pins on the MintDuino 328?
From a little research I think what you have to do once you install the chip into your Uno board is to select the older Duemilanove w/ ATmega328 in the IDE Tools/Board menu before you upload a sketch, as it appears your chip uses the older bootloader that the Duemilanove uses.
I just got it to work, without even pressing the reset button.
The trick was to select the Arduino Duemilanove w/ ATmega328, I had just been trying Arduino Uno these last few tries.
I think the original problem may have been that I hadn't downloaded the FTDI drivers.
thanks, I found that also, but still nowhere on what speed I should be "talking" at. I added a "board" listing and named it PL2303 and edit it as I find new things. I've changed the baud to 57600 but haven't tried it yet.
WinstonP:
thanks, I found that also, but still nowhere on what speed I should be "talking" at. I added a "board" listing and named it PL2303 and edit it as I find new things. I've changed the baud to 57600 but haven't tried it yet.
Your really don't need to define a new board type. The PL2303 USB converter module will work just fine using the existing Arduino Duemilanove w/ ATmega328 as the board type. If you some reason you do feel the need to create a new board type, below is the details that the Dumilanove bootloader uses.
thanx for the heads up but so far nothing is working. is there a "board" type that I can use to plug the MintDuino 328 into my Uno board and upload the bootloader?