it used to upload, but now its not. help! :sob:
vbee:
it used to upload, but now its not. help! :sob:
so little information
Please do this:
- File > Preferences > Show verbose output during: > compilation (uncheck) > upload (check) > OK
- Sketch > Upload
- After the upload fails you'll see a button on the right side of the orange bar "Copy error messages". Click that button.
- Paste the error messages in a reply here USING CODE TAGS (</> button on the toolbar).
Maybe you burned up the Arduino.
Maybe you are not following the upload sequence properly.
Maybe you have a bad cable.
Maybe you clobbered the bootloader.
Maybe you should try the loopback test.
Maybe you should try some troubleshooting.
https://www.arduino.cc/en/Guide/Troubleshooting#upload