I've got a through hole PCB (one of them that has millions of prepunched holes). I've used them before with typical jumper wire to move off the breadboard. I've got a problem - MOSFET on one of these PCBs, they typically require more current than a bit of CAT5 cable will accomodate. Any thoughts?

Through Hole PCB - Traces?

Grumpy_Mike December 24, 2013, 9:27am 2

Go over the traces with tinned copper wire to reinforce them.

Topic		Replies	Views
Holes too small on my PCB - now what? General Electronics	9	8467	May 6, 2021
vias on homemade pcb General Electronics	7	4117	May 6, 2021
DIY PCB idea General Electronics	6	1086	May 6, 2021
pcb boards with seperated compnent holes.. Frequently-Asked Questions	8	1221	May 6, 2021
D.I.Y. Double Sided PCBs, NO plated through holes necessary. General Electronics	8	7594	May 6, 2021