Greetings. I have just started tinkering with the Arduino system. I have purchased the Arduino "UNO" board, the 1602 Board keypad, and a little 5 Volt motor c/w a UL2003 Board. (This can be checked out in this You Tube Video.:- YouTube ) Go in 20 to 25 seconds and you will see the board. If I was to use just the UNO board, power comes from pins 6,7,8,9,however when I place the 1602 keypad on the board I have covered all those pins, which pins do I use on the keypad to connect the power to the UL2003 board. I have a program already loaded into the UNO to control the motor. I just need to hook the wires up and I'm ready to go.
Any help for a old fellow (75 yrs) would be greatly appreciated.
And a MERRY CHRISTMAS to all.
Harvey
in Kelowna,BC.