I made a board with a mega328, GPS Module, a few LED's and SD Card on it and I notice that when the battery still has plenty of power (3.9V (LiPo) with the mega328 operating at 3.3V internal 8 MHZ clock source) it will enter what I think is a brown out reset loop. I think the culprit may be the fact…

Brown out reset loop due to thin traces?

dan333 February 18, 2013, 12:25am 9

8 mil traces, buck-boost converter. OOF! Is this on the same pcb? I don't know which part
you're using, but see the picture, same idea for buck-boost,

Topic		Replies	Views
Brown out when using single li-ion cell General Electronics	7	863	May 6, 2021
Trying to figure out what is draining my battery Project Guidance	7	3335	May 5, 2021
What's problem with brown out ? Microcontrollers	19	8123	May 6, 2021
Can watchdog trigger replace need for brown out detection? Project Guidance	30	3359	May 5, 2021
Avoid Arduino reset (due to voltage drop?) when switching on somethig. General Electronics	17	7826	May 6, 2021

Brown out reset loop due to thin traces?

Related Topics