ahh this is killing me!
so I decide to do the 6 wire method as I was already half way through doing it anyway, the computer reads the touch pad no problem.
the Kaoss pad however -.-"
it just wont...
If I change the midi signal to
midiCC(0xC0,0,touchX);
I can control the setting the touch pad is on (the command Im hoping to use for the encoder.)
but when I put it back to midiCC(0xB0,12,touchX);
its just wont bloody work! i have literally tried everything...im just completely out of ideas as to why its not working... Every single midi site ive gone to has basically told me that the command is correct.
pheh....a little help anyone?
xD