Palliser:
- Make sure that the variant files (.c, .h) located in
...\arduino-1.5.2-windows\arduino-1.5.2\hardware\arduino\sam\variants\arduino_due_x\ contains the CAN0 and CAN1 pin definitions.
Palliser,
Number 2 and 3 are an affirmitive, but can you explain in detail where these pin definitions should be at? I only found DAC0 and DAC1 pins along with the CANRX and CANTX in variant.h
Sherlock3112:
jspobuk: I don't want to sound like I'm stating the obvious, but since you say you're new to it then it may have been overlooked.... make sure the serial bitrate in your serial console is the same as the one in the serial.begin line. Without the code to hand I can't be certain, but I don't think there's any "halts" in the code before the first bit of code you post, and mismatched speeds could be a prime culprit there.
I checked, and both are running at 9600. So I believe that should be good. Thanks for the suggestion though, I am new so it's not that obvious.
Thanks