Go Down

Topic: Core 1.0.7 released (Read 6196 times) previous topic - next topic

jpoppe

The 5V pin can output 500mA if the bard is powered via USB and 1A if powered via the barrel jack. There is a third choice and you can get 1.5 A from the USB bus by shorting "1.5A SHORT" on the board.
Thanks for clarifying this!

The EEPROM is not advertised since it's not a real EEPROM but a flash "partition" used as EEPROM (byte addressed)
I already understood it's not a real EEPROM but now it looks like there is no support at all if you look to the specs page (Just my 2 cents).

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy