mikedehaan:
Hahaha, well...my plans were foiled. I just tested out the new build in the full system and found that you cannot hold the trigger down and switch from the "F" position to "FA" (to turn on the board). So I switched the programming to use the pushbutton rather than the trigger to enter programming mode.Other than that, I made some tweaks to Auto-Response and the new build mostly works. I say mostly because successBlink is not working for some odd reason. I'm baffled why it is not working on the board when it does on the testbed, but I'll figure that out later. successBlink is supposed to blink green + red three times to indicate that your changes have been saved to the EEPROM.
I'm starting a google code project with everything I do. I expect to put documentation, pictures, videos, etc up there.
Google Code Archive - Long-term storage for Google Code Project Hosting.
If you'd like to contribute to some of the documentation etc, let me know. I think all I need is an email address of yours to set you up.
From this point forward, new code and builds will be posted there.
Hello mikedehaan, any news about your firmware?
What things I need to flash my phenom with your firm?
Correct me if I'm wrong:
-
ATTINY44A-PU
http://www.ebay.com/itm/2x-8-bit-Microcontroller-ATTINY44A-PU-/221023275589?pt=LH_DefaultDomain_2&hash=item3376038a45 -
Your HEX File
================================
I need desolder the original chip from my board? or exist the posibility to program it directly in the board? Or is read only?
Your work is awesome!
Sorry for my very poor English... (Entiendes español?)