I am trying to remotely program an Atmega328 with UNO bootloader using an XBEE. For the reset line, I use XBEE's I/O line passing, with the programming done via the XBEE's serial link. The /RST, TX, and RX signals at the transmitting XBEE and remote Arduino show proper levels and polarity. But I get…

programming Arduino remotely via XBEE

pmail March 7, 2013, 6:44pm 3

I am using series1 XBEEs (not ZIGBEE).

Topic		Replies	Views
using an XBee usb to serial board to communicate with ATMega328P Microcontrollers	1	1649	May 6, 2021
Programming Arduino wirelessly via XBee Interfacing	12	12576	May 6, 2021
Arduino Uno board (as TTL programmer) programming ATmega328 IDE 1.x	1	557	May 5, 2021
Bypasing the atmega328 on Arduino Uno Networking, Protocols, and Devices	2	572	May 6, 2021
Programming Arduino via xbee Networking, Protocols, and Devices	4	1380	May 6, 2021