Go Down

Topic: Problem using ESP-13 from Jaycar (Read 280 times) previous topic - next topic

jeremycostello

Has anyone had any success using the esp-13 from jaycar?
(https://www.jaycar.com.au/arduino-compatible-esp-13-wifi-shield/p/XC4614)

The shield is being powered through my Arduino UNO. I have not been able to communicate with the shield via the UNO at all but it does create its own wifi network AI-THINKER which i can connect to without a password bit cant do anything from there.

Doing some reading it seems my only chances or getting it working is to flash the chip, but i dont have the gear to do it yet.

If anyone has had any luck with this shield out of the box?

micomator

I have the same set up, but experience the same you do. Did you have any luck?

jmcatamney

Have you guys had any luck with this particular combination. I have tried numerous combinations without any success. Starting to think its a bad selection of product

Go Up