So I'm reading this. Say I wanted to use this without a breakout board on an Arduino. VDD goes to a 3.3 or 5 V pin, ground goes to a ground pin, but are there any pins with a 10k ohm pull up resistor built in? What pin would the serial clock pin go to? Basically how would a complete newb hook this up to an Arduino, step by step.
What kind of connectors would I use for the pins on the sensor (it explicitly says no soldering).
As for step by step -- if you are asking us to design your system and write codes -- the rate of the "old-timers" can seem awful prohibitive. May I send you a rate sheet? ]