Go Down

Topic: Yun 17.11 Reboot prerelease (Read 13348 times) previous topic - next topic

gpedder

Hi, the links arent' working. Is this project dead?

AgroMeInc

Doesn't seem dead but this thread does.

try these: https://github.com/arduino/yun-go-updater/releases


jhsung97

Finally a chance to try it out ... so far the auto updater is not working. Needs sudo for the tftp daemon, assumes there isn't one already running (closed my existing) and then an IP address conflict (switched off local machine causing the conflict)

I'm still getting a timeout at flashing the boot loader: ...


Flashing Bootloader
tftp 0x80060000 u-boot-arduino-lede.bin
eth0 link down
FAIL
eth1 link down
FAIL
Using eth0 device
TFTP from server 192.168.99.200; our IP address is 192.168.99.201
Filename 'u-boot-arduino-lede.bin'.
Load address: 0x80060000
Loading: T T T T T T
expect: timer expired after 30 seconds
Could not get your IP address, check your network connection

*Update*: seemed like the ip address setup was a bit finicky about being on an existing network, got it working after isolating on a cross over cable.

Nice to see an update on the Yun, off to explore ! Thanks :)


Finally a chance to try it out ... so far the auto updater is not working. Needs sudo for the tftp daemon, assumes there isn't one already running (closed my existing) and then an IP address conflict (switched off local machine causing the conflict)

I'm still getting a timeout at flashing the boot loader: ...


Flashing Bootloader
tftp 0x80060000 u-boot-arduino-lede.bin
eth0 link down
FAIL
eth1 link down
FAIL
Using eth0 device
TFTP from server 192.168.99.200; our IP address is 192.168.99.201
Filename 'u-boot-arduino-lede.bin'.
Load address: 0x80060000
Loading: T T T T T T
expect: timer expired after 30 seconds
Could not get your IP address, check your network connection

*Update*: seemed like the ip address setup was a bit finicky about being on an existing network, got it working after isolating on a cross over cable.

Nice to see an update on the Yun, off to explore ! Thanks :)




jhsung97

Hello,
TFTP server is your computer. run TFTP util on your computer.
Then on u-boot status, put the cmd 'setenv serverip your ip'
 Next, put 'setenv ipaddr board's ip ' . You can use any thing as board ip if
it is in your network. Then re try.

Have a good luck.

jhsung97

Hello, thanks to new update.

I tried it but got a fail. So, I set up it manually resulting in a success.

Anyone who try it manually should be careful at some points.

You should use a new disk-expander util because old one yields a insufficient memory alarm.
(use the new version in the go-update package).

Next, you should update your u-boot at first due to a large package.

I am really happy due to this new update. I have some problems in using the python in the old version
(especially pip was not working due to certification problem). Now, it works fine.
Thanks.


Go Up