I recently got an esp8266, and hooked it up according to guides and youtube videos. I noticed that when uploading, it was acting very weirdly, and often refused to be uploaded to, getting the error:
I looked up the issue, and many people seem to think the arduino doesnt have enough power for the 3.3v chanel. I used the 5 volt one, and made a voltage divider with a 2k and 1k resistor. I have also checked, and the power seems to be flowing. Whenever now i turn on the board, non of the lights flash like they used to. I did get a short flash when connecting to power, but thats it. It does neiter respond to uploading, and i am very afriad that the board is toasted, but i dont think i could've done somethink wrong.
You can’t power a module in this way. The voltage divider you have constructed will deliver a couple of mA only. This may be suitable for protecting a 3 volt pin from a 5 volt signal but for powering the device it is far too little.
6v6gt:
You can’t power a module in this way. The voltage divider you have constructed will deliver a couple of mA only. This may be suitable for protecting a 3 volt pin from a 5 volt signal but for powering the device it is far too little.
Thank you for the help. Will it work if i use a LM1117T regulator and a capacitor instead?