Fritzing is finally reaching its destination and will soon launch "Fritzing Fab" - a production service for PCBs you designed with Fritzing. Eventually you will even be able to order any project as a complete kit with parts. And hopefully we can sustain Fritzing development through this service.
In order to kick it off, we are having a little Fritzmas special: we will produce 24 of your Fritzing-made designs as a free service! Just send us your sketch by December 9th.
I've just been over to the fritzing site and got the new version. the biggest change I've seen is a whole lot more parts - this alone is well worth the upgrade.
Heeyyy, that's pretty nifty! I've used fritzing a few times to show circuit diagrams.. never thought of it as a PCB service, but I like the idea! I'm a very visual person. lol
Hi Rico,
thanks for the suggestion. I was going to say that you could just use a 20-pin mystery part as a placeholder, but those use 10mil instead of the 2mm pin spacing of the Xbee. It would only work if you used the Xbee breakout board (Breakout Board for XBee Module - BOB-08276 - SparkFun Electronics) in the middle..
I guess we can create it pretty quickly, though - so just start building your sketch and I promise we will deliver the Xbee part in time for the deadline.
How about that?
Does anyone want to work on a programming shield for the arduino to submit for fritzmas?
This would be a board with one or more empty sockets for programming atmega and attiny devices via icsp and maybe a 6 pin header for an ICSP cable connection. Not a lot to it besides some traces and some leds but it would be a handy thing to have around.
The programmer code is commonly available and the project has been done before but a nice little shield would be cute.