ok..
I took BRAND NEW 4.7k Ohm and a 10k Ohm resistor (fresh out of the pack)... and put them in place
4.7k in between the +Vin and +Vout
the 10k between + and the - (same as illustrated in the picks.. (but the values changed)
and I 'again' get the same results? once I turn the PSU up.. and I get to +5v.. Im already capped at 1023 analog value??
what the 'heck' am I missing here? lol..
I dont even have the LEDS in the mix or part of the project until I can fix the analog read values to be 'somewhat' near my ranges..??
I mean damn.. I only have 2 wires going to the Arduino!!! LOL GND and A5
some resistors..and two leads going to my variable PSU..