I thought it was just simpler with the ch341. How can I do that with the Arduino. And more important, I can do that on my specific chip?Thanks!
Thanks, but I'm still not able to connect to my chip.I use this schematic for the voltage conversion from 5V to 3V (where I assume that the non _L pin stands for the Arduino pins, and the pins with the _L in the end are the chip pins):Then I just run the FlashDiagnostic example from the library you linked (without changing anything of the code) and it's no work at all.What I'm doing wrong here? Thanks!
So I'm not able to interface to my chip because of the resistor dividers? So I don't understand why on the GitHub page of the library the Arduino UNO is completely supported...What do you suggest to interface this chip? I see that the ESP8266 are supported, can I use my NodeMCU?Also, I don't understand what the TiBackup and the Lifter (with relative schematics) are.Many thanks!