After careful consideration, some of the cheaper resistors particularly the 68ohm 100+ packs cheapies have even thinner legs than i'm used to, not sure if it's a good or bad thing...
So after crushing the arm off my driving specs (by sitting on them) the tiny tiny screw vanished to never be seen again and i don't have any tiny enough, low and behold the cheap 68ohm resistors from ebay are perfect size
I cut one end off leaving the tip, dropped the resistor in, apply solder, fixed, small intrusive and I'm the only geek who drives wearing glasses with a resistor as a fix LOL sad the things i do, but anyway it works fine it acts as a pin no squeaks, seems perfectly good to use, i'll know when i use them to drive with next.
Are you sure this will work as planned ?
Could be the camera (or me) but this doesn't seem to be a 68 Ohms resistor.
Maybe you should check the value before you put the load on it.