Go Down

Topic: Encoder - Which Type of Output ? (Read 72 times) previous topic - next topic

TraCerT

Hello

I would like to order an incremental encoder to my project of inverted pendulum. And there is a question I have to You: Is better to order an encoder with pushpull output or with open collector output to this project ?

Greetings,
TraCerT

JohnRob

You don't give enough information to proevide a definitive answer but you might consider the following:

In a push-pull sensor the "high' output  will be approximately the power to the sensor.  If this is 5V and you have a 3.3v Arduino you will have to do some level shifting.

With open collector you could use the internal pull-up of the controller or at worst a few resistors.

Good luck





Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy