I see a dot in the green line.
I attached a highlight of what i mean.
That means 2 wires are connected at that point.
If you do that on a breadboard, Fritzing! will connect the wire to the breadboard as well and make an invisible connection to the pin under your wire.
That pin happens to be in the GND rail of your breadboard.
If you're going to use the other modes (so not breadboard mode) of Fritzing!, then you'll see a connection of the green wires to the GND rails.
This is of course not what you want.
But if you're just going to use the sketch as a guide for your jumperwires, you're good.
Also if you already connected all and made your sketch afterwards, it will be good and you'll be ready to test.
Don't forget to connect the capacitors.
