Vaisala WXT520 weather sensor

Using Arduino Networking, Protocols, and Devices
4

This code will read, and store all the serial data between start and end of packet markers:

#define SOP '<'
#define EOP '>'

bool started = false;
bool ended = false;

char inData[80];
byte index;

void setup()
{
   Serial.begin(57600);
   // Other stuff...
}

void loop()
{
  // Read all serial data available, as fast as possible
  while(Serial.available() > 0)
  {
    char inChar = Serial.read();
    if(inChar == SOP)
    {
       index = 0;
       inData[index] = '\0';
       started = true;
       ended = false;
    }
    else if(inChar == EOP)
    {
       ended = true;
       break;
    }
    else
    {
      if(index < 79)
      {
        inData[index] = inChar;
        index++;
        inData[index] = '\0';
      }
    }
  }

  // We are here either because all pending serial
  // data has been read OR because an end of
  // packet marker arrived. Which is it?
  if(started && ended)
  {
    // The end of packet marker arrived. Process the packet

    // Reset for the next packet
    started = false;
    ended = false;
    index = 0;
    inData[index] = '\0';
  }
}

You can remove all the SOP stuff, since you don't have a start-of-packet marker. Set started to true when you send the 0R0 command.

Where it says "The end of packet marker arrived. Process the packet", you can store the data in inData to the SD card. Make sure that inData is sized appropriately for your amount of data, and that the limit values are adjusted appropriately.