I'm still having the error listed above, and can't figure out what it is, I've run (and re-run and re-run) the setup.command file.
I thought 0007 might help, because it didn't need the setup.command file, but still no luck.
The exact output is:
Error inside Serial.<init>()
gnu.io.PortInUseException: Unknown Application
at gnu.io.CommPortIdentifier.open(CommPortIdentifier.java:344)
at processing.app.Serial.<init>(Serial.java:127)
at processing.app.Serial.<init>(Serial.java:72)
at processing.app.Uploader.uisp(Uploader.java:156)
at processing.app.Uploader.uploadUsingPreferences(Uploader.java:78)
at processing.app.Sketch.upload(Sketch.java:1693)
at processing.app.Sketch.exportApplet(Sketch.java:1755)
at processing.app.Editor$40.run(Editor.java:1892)
at java.awt.event.InvocationEvent.dispatch(InvocationEvent.java:209)
at java.awt.EventQueue.dispatchEvent(EventQueue.java:461)
at java.awt.EventDispatchThread.pumpOneEventForHierarchy(EventDispatchThread.java:269)
at java.awt.EventDispatchThread.pumpEventsForHierarchy(EventDispatchThread.java:190)
at java.awt.EventDispatchThread.pumpEvents(EventDispatchThread.java:184)
at java.awt.EventDispatchThread.pumpEvents(EventDispatchThread.java:176)
at java.awt.EventDispatchThread.run(EventDispatchThread.java:110)
I'm on OS 10.4.8 and have firmware version 1.18 of the USB arduino. I've gotten the same errors in both 0006 and 0007 versions of the software, both before and after running the setup.command. Also I had attempted to run serporoxy to connect with Flash, but never had any luck.
I'm assuming that the port is in use by something else (possibly with serproxy if it's something that doesn't quit after logging out), but I don't know what, or how to clear it.
Any ideas would be great. Or instructions on a full uninstall would also be nice, so that i can start from scratch.