I went trying out my LED by connecting it to the 5V and the ground pin ( 2k ohm resistor is also present ). Suddenly, the LED was just flickering and died out. I was running one of my self-programmed 'reset' mode below. But how come this could happen? void setup() { ; } void loop() { ; }

Need some help!!

low5545 July 5, 2011, 12:11pm 3

I dont think so

Topic		Replies	Views
Need some help!! IDE 1.x	4	1324	May 5, 2021
I fried my LED, why ? General Electronics	11	3290	May 6, 2021
LED flickering by itself... hmm, why ? Programming Questions	8	1762	May 5, 2021
LED won't turn on, help please LEDs and Multiplexing	20	502	August 29, 2023
Bright LED's Troubleshooting	10	2608	May 6, 2021