I want to upload with an FTDI breakout board to this cheap board. The driver is installed on my Mac book but the sketch won't upload. The appropriate pins are connected. Any idea what I am doing wrong?

FTDI basic breakout upload problem

CrossRoads May 26, 2013, 11:29pm 3

What do you have connected?
Common issues:
Rx to Tx, Tx to Rx, are swapped.
No 100nF/0.1uF cap between FTDI's DTR and board's Reset - requires manual reset
Gnds not connected.

Topic		Replies	Views
Uploading problem with FTDI Chip Arduino Due	11	3555	May 6, 2021
Issues uploading to Arduino using FTDI cable IDE 1.x	1	644	May 5, 2021
PC Can not upload to Barebones with FDTI breakout board Project Guidance	14	6152	May 5, 2021
Upload sketch through FTDI to Arduino Micro? Microcontrollers	9	4298	May 6, 2021
Cant get the FTDI Basic Breakout to reset my home made Arduino IDE 1.x	3	2660	May 5, 2021

FTDI basic breakout upload problem

Related Topics