claw controlled by 1 button

Using Arduino Project Guidance
4

I like making a pin high then pulling it low to ground. Easy to test just using a piece of wire for a switch.

//zoomkat servo button test 12-29-2011

#include <Servo.h>
int button1 = 4; //button pin, connect to ground to move servo
int press1 = 0;
int button2 = 5; //button pin, connect to ground to move servo
int press2 = 0;
Servo servo1;

void setup()
{
  pinMode(button1, INPUT);
  pinMode(button2, INPUT);
  servo1.attach(7);
  digitalWrite(4, HIGH); //enable pullups to make pin high
  digitalWrite(5, HIGH); //enable pullups to make pin high
}

void loop()
{
  press1 = digitalRead(button1);
  if (press1 == LOW)
  {
    servo1.write(170);
  }    
  
  press2 = digitalRead(button2);
  if (press2 == LOW)
  {
    servo1.write(10);
  }
}