Adjust microstepping on BED from Arduino?

Hi,

This might be a really simple / stupid question:

On the BED, there is three terminals (M1, M2 and M3) which decides the microstep settings. They have internal pullups (20K). To change microstep setting, I tie one or more to ground depending on what setup I want.

If I dont connect them to ground, but to the Arduino's digital pin (output), would it be possible to adjust microstep settings by setting the digital output either HIGH or LOW?

-Aleksander

Yes. That is how it is meant to work.

...R

BED?

MarkT:
BED?

BigEasyDriver.

Or a place to sleep.

Never seen that abbrev. before! Is the EasyDriver "ED" then?