I've used this little buzzer from Sparkfun, but it's not very loud. It works using the tone function.
I'm wondering if anyone could tell or would know if this one is louder? http://www.digikey.com/product-detail/en/AI-3035-TWT-3V-R/668-1204-ND/1745457?cur=USD
The datasheet says 100dB @ 3V, 10cm. And does this one work off the tone function, or do I just supply it with 3 volts? Looking at the data sheet on it, it seems I just supply 3 volts. I'm hoping to find a fairly loud buzzer to alert a me if I'm starting to max out my motor speed on a segway, so the rider can know they're fixing to fall over if they don't slow down.
Thanks, Crossroads,
My segway is powered by 24V, but I only have 5 volt coming onto my control board (supply from Sabertooth motor driver). I'm hoping to find one that is loud enough, but is PCB mountable, I like cutting out extra wires anytime I can.
It will, however be in a plastic enclosure, at my feet, like this:
First one says "Indicator, Internally Driven", so just DC on should make it noisy.
Needs up to 130mA tho, so transistor control is needed.
The '3904 should work, make sure you leave a way to put a heatsink on it.
"The useful dynamic range extends to 100 mA as a switch"
I'm thinking a higher rated part might be better.
The datasheet charts only show performance up to 100mA.
130mA? Who knows.
Oh yeah, I remember now. I'm still catching on to these transistors and MOSFET's. I need one that's rated well over what I'll actually be using in current.
This one should work well.
That's a magnetic buzzer and not a piezo buzzer. Before anything else, you might try
coupling it to the Arduino through a 10-uF cap, and wiring a 1N914 diode across the
buzzer terminals, anode to gnd. They also sometimes get louder if you put a piece of
black electrical tape over the hole. After that, you need more current drive, as Bob says.
Beware of radioactive sources in ionizing types. May be anything up to 120 db at 1m
each 6db (aprox) is twice as loud - check the distance at which measurements are taken.
I used to make bespoke sounders for the military (supposedly 240db although I quoted then as "very loud" as my meter went off scale), they made your face hurt when testing through ear defenders. Highly illegal in the UK. My neighbours would ask, did you hear that damn alarm again yesterday? Nooooooo
CrossRoads:
I would add a series resistor from D8 to the gate to protect against gate capacitance charge/discharge.
OK. Like a 330ohm or a 1K? I'm slowly learning about mosfets. I think the 1K would make it turn on slower? ...but in the case of a buzzer, it shouldn't matter.
I figured it out how to make a Piezo loud after way too long. You add an Auto-transformer to the circuit that you can get at the dollar store. I made an instructable on it here:
