Go Down

Topic: usb not recognized (plaese help) (Read 1 time) previous topic - next topic

zhee21

I have a miniduino (ATmega 328) with Prolific usb chip. I bought it two weeks ago. it works well. But when a week I use, it not recognized by my windows7. :-[

Device type: Universal Serial Bus controllers
Manufacturer:(Standard USB Host Controller)
Location: Port_#0001.Hub_#0001

Devica Status: Windows has stopped this device because it has reported problems. (Code 43)

any ideas for this problem? it's very helpful :D... thanks before..

Coding Badly


Is there a USB hub between the miniduino and the computer?

jcarrr

Twice we have had computers lose track of the drivers for the FTDI usb chip and had a terrible time getting the proper drivers reinstalled.  This finally did the job:

http://www.ftdichip.com/Drivers/CDM/CDM20802_Setup.exe

THIS IS NOT THE SOLUTION FOR YOUR PROBLEM! It is the solution for other people's problem.

A similar solution probably is available from and for  Prolific parts

JC


Go Up