Xbee Shield Version 2 from NKC Electronics

Forum 2005-2010 (read only) Hardware Troubleshooting
1

Hello everyone,

I'm having a problem finding info on the version 2 xbee shield from NKC. I bought 2 of these a few months back. I'm now starting to play with them. I'm kind of leery about inserting my xbee modules into them right now ... since I don't know what jumpers J1 & J2 do. I plugged the shield onto my arduino ... can't seem to read any voltage off the shield. Zero volts from GND to 3v3 on the shield.

Anyone else having this problem?

thanks,
Phil

2

Have you checked with NCK yet? That's where I'd start. Look at the documentation.