I made a board with a mega328, GPS Module, a few LED's and SD Card on it and I notice that when the battery still has plenty of power (3.9V (LiPo) with the mega328 operating at 3.3V internal 8 MHZ clock source) it will enter what I think is a brown out reset loop. I think the culprit may be the fact…

Brown out reset loop due to thin traces?

jerseyguy1996 February 18, 2013, 12:27am 10

To do that, do I just change this line in board.txt:

atmega328bb.bootloader.extended_fuses=0x05

atmega328bb.bootloader.extended_fuses=0x06

and then burn the bootloader again?

Topic		Replies	Views
Brown out when using single li-ion cell General Electronics	7	863	May 6, 2021
Trying to figure out what is draining my battery Project Guidance	7	3335	May 5, 2021
What's problem with brown out ? Microcontrollers	19	8126	May 6, 2021
Can watchdog trigger replace need for brown out detection? Project Guidance	30	3362	May 5, 2021
Avoid Arduino reset (due to voltage drop?) when switching on somethig. General Electronics	17	7834	May 6, 2021