So guys ... if got an DFRobot Mega with ATMega1280. This is the code: void setup(){ pinMode(39, OUTPUT); } void loop(){ digitalWrite(39, HIGH); Serial.println(digitalRead(39)); delay(100); digitalWrite(39, LOW); Serial.println(digitalRead(39)); delay(100); } To pin 39 is an Opto…

digitalRead always LOW / 0

system April 15, 2012, 1:46pm 3

no i don't

Topic		Replies	Views
Opto Isolator breakout board Project Guidance	13	3441	May 5, 2021
is this safe? Interfacing	9	1901	May 6, 2021
opto isolator Interfacing	8	2533	May 6, 2021
Arduino output low is at 0.5V General Electronics	6	1040	May 6, 2021
analogWrite(3, 255) == digitalWrite(3, HIGH)?? Troubleshooting	7	9207	May 6, 2021