Go Down

Topic: Controlling Speed and Time of DC Motor for Magnetic Stirrer (Read 5666 times) previous topic - next topic

CHUCKGENE

Hi Everyone, I'm very new to Arduino and hoping for some help on my project. I'm trying to spin a DC motor from 70 to 255 in 4 equal steps. Ramp to speed over 3 minutes with each step and hold for five minutes. At the fourth step run motor for 15 mins. then stop for 5 mins. Reverse motor direction and repeat the process in reverse and shut off. I have set up a UNO with a L298N. The motor is less than 1 amp. Thanks All.


Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy