Hi every one.
I had bought 2 nano-328 from dealextreme. My problem is that when i run the default blink program changing the led pin 13 to 8. the program doesn't seem to run.The output of pin D8 is high always.
When i change the led pin to D7 the sketch runs. But however the D8 pin is high.
Please note that the so called "Arduino" boards sold by dealextreme are unauthorised clones. This means that if they don't work (and we're getting a lot of feedback about that) you are on your own.
Official Arduino boards will be replaced by authorised resellers no questions asked.
I think its getting more and more common, people buying cheap stuff from ebay or China and when its not working, they come crying about it.
Are people just getting more and more stupid ?
I thinke this question is the fuse CKOUT has been program,you can re-program the bootloader if you have ISP download cable,the bootloader file is in the path: \arduino-0022\hardware\arduino\bootloaders\atmega\ATmegaBOOT_168_atmega328.hex?
Fuse setting as follow:
atmega328.bootloader.low_fuses=0xFF
atmega328.bootloader.high_fuses=0xDA
atmega328.bootloader.extended_fuses=0x05
atmega328.bootloader.lock_bits=0x0F
good luck!