hi everyone............ i'm new to arduino i was lately working on a project . i faced a problem in my code, the problem is i can't use the button i attached to break the switch statment. ie. i have the following switch statment if (Serial.available()>0 && sensorread==LOW) { int incomingseria…

Using a button to continue your loop, or to break in switch case

liuzengqiang March 28, 2011, 4:17pm 3

The complete code will be helpful. Also how sure are you that you connected the button correctly? Have you tested the button?

Topic		Replies	Views
Arduino looping in switch case until button pressed again Programming Questions	9	508	May 6, 2021
Arduino looping in switch case until button pressed again Programming Questions	3	342	May 6, 2021
Looping switch case until button press Programming Questions	7	1465	May 6, 2021
help with "switch case" Programming Questions	23	6206	May 5, 2021
switch case statement break not working on button press Programming Questions	10	2494	May 6, 2021