I need to use arduino to commande 2 motors, and read data from an accelerometer and a gyroscope. So the Arduino MotorShield (http://arduino.cc/en/Main/ArduinoMotorShieldR3) seems to be perfect for that.
But i have to use 30V motors, and the motorShield limit seems to be 18V.
As the L298 used on the motorShield work with 48V motors, is there a way to use 30V motors on the motorShield ?
Or is possible to make some little changes on it to make it work ? (which one ?)
If not, is there another card compatible with arduino that I can use to do what I need ?
You should give some info about the motors. A 30V motor usually is a higher power motor. What are the current requirements? What are the motor driving?
Referring to the Arduino Motorshield schematic diagram, you could supply 12Vdc to the card and connect you 30 V DC motors and see if they are powered enought for their duty.
Note: I am using an L298 with 30 VDC driving a stepper motor 1,2 Nm and works very well.