I am trying to use my serial port in the Arduino IDE to set the IP protocol on my Arduino Wifly shield. When I go to enter "$$$" to place the serial port into command mode, nothing happens. Any thoughts?

Serial Port will not go into command mode after entering $$$

system December 4, 2012, 10:30pm 4

Would I need to connect the two pins RX and TX?

Topic		Replies	Views
WiFly Configuration Process - No response to $$$ Networking, Protocols, and Devices	5	1732	May 6, 2021
Can't get Wifly RN-XV into command mode Networking, Protocols, and Devices	12	4975	May 6, 2021
Lilypad + Wifly Interfacing	2	1100	May 6, 2021
Getting My WiFly Going Programming Questions	6	2020	May 5, 2021
WiFlyHQ cant connect with any examples Networking, Protocols, and Devices	1	970	May 6, 2021