MG811 CO2 Sensor

Is there any code to arduino in order to read from the MG811 CO2 Sensor?

Google will no doubt tell you if there is...

I didn't find anything on google.

Well there probably isn't then :stuck_out_tongue:

Everywhere I know of that would have code like that would show up on google.

Hi!
at the end do you know now the cod for co2 sensor?
thanks, I must use, too ::slight_smile:

@aranciagrossa
Q1: Do you have a link to a datasheet?
Q2: Do you have experience with Arduino projects? or uProc in general?
Q3: what is your goal you want to achieve?
Q4: The supplier of the device, does it have examples on his website? (assuming she has one)


update
A1: http://www.parallax.com/Portals/0/Downloads/docs/prod/sens/MG811Datasheet.pdf
Seems it need some signal boosting to provide a voltage Arduino will handle properly. Furthermore You need a quite stable 6Volt for the heating unit.

at This product is no longer available.
you can mail the supplier

Some hardware diagrams