I got a Arduino Duemilanove recently.
I have not been able to upload any programs to it.
I am using Arduino-0012 (It was the version used in the Nuts & Volts magazine workshop series), on Windows XP.
I am pretty sure I got the FTDI driver installed correctly (and the right COM port), since the RX LED blinks a couple of times when I start a download. TX never blinks.
I set upload.verbose=true, and get these messages:
Binary sketch size: 1124 bytes (of a 14336 byte maximum)
C:\arduino-0012\hardware/tools/avr/bin/avrdude -CC:\arduino-0012\hardware/tools/
avr/etc/avrdude.conf -v -v -v -v -pm168 -cstk500v1 -P\.\COM4 -b19200 -D -Uflash
:w:C:\Documents and Settings\Rusty\My Documents\Arduino\sketch_100102a\applet\sk
etch_100102a.hex:i
avrdude: Version 5.4-arduino, compiled on Oct 11 2007 at 19:12:32
Copyright (c) 2000-2005 Brian Dean,
System wide configuration file is "C:\arduino-0012\hardware/tools/avr/e
tc/avrdude.conf"
Using Port : \.\COM4
Using Programmer : stk500v1
Overriding Baud Rate : 19200
avrdude: ser_open(): setting dtr
avrdude: Send: 0 [30] [20]
avrdude: Send: 0 [30] [20]
avrdude: Send: 0 [30] [20]
avrdude: Recv:
avrdude: stk500_getsync(): not in sync: resp=0x00
avrdude: Send: Q [51] [20]
avrdude: Recv:
avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x51
avrdude done. Thank you.
When I plug in the board (USB) or reset it, the pin13 LED blinks short-short-long every 1 second or so.
Any suggestions of what to do?
Thanks in advance,