MKR1000 blink with external led?

Hardware MKR Family MKR1000
7

I tested this configuration and code and it work. This is going to help me with my post.

Thanks.

Maki_bOo:
Hello , sandeepmistry, this is my wiring:

2984×5312 1.88 MB

And the sketch that I'm using which I tested with a Yun Board is the following (I have tried different pin combinations already):

const int buttonPin = 7; // the number of the pushbutton pin
const int ledPin = 6; // the number of the LED pin

// variables will change:
int buttonState = 0; // variable for reading the pushbutton status

void setup() {
// initialize the LED pin as an output:
pinMode(ledPin, OUTPUT);
// initialize the pushbutton pin as an input:
pinMode(buttonPin, INPUT);
}

void loop() {
// read the state of the pushbutton value:
buttonState = digitalRead(buttonPin);

// check if the pushbutton is pressed.
// if it is, the buttonState is HIGH:
if (buttonState == HIGH) {
// turn LED on:
digitalWrite(ledPin, HIGH);
} else {
// turn LED off:
digitalWrite(ledPin, LOW);
}
}